Aluminum Belt Trailer Specifications
Floor Chain is 88 XH Pintle Chain, 2 strands Easy access belt adjustment at front of trailer 2 ply belt flaps full width of floor Bolt on 5thwheel Hydraulic Gear drive 130000 in-lb, 18000 pound radial load 2 15/16 rear drive shaft, with weld on sprockets and weld on splined hub Hydraulic top hinge Main gate, with center knife gate and cylinder locks Plastic floor liner is UHMW 3/8 thick, sides fully lined with plastic 3/16 HMW to top Extended rear discharge with wings on rear of trailer Hydraulic pressure line filter, manual / electric control valve Hydraulic floor speed control Main frame rails and suspension sub-frame are steel Side and slope sheets are post and hat aluminum construction, riveted 50000 pound landing gear ABS brake system , Dot lighting, Reflective tape 11 x 22.5 on 10 bolt hub pilot aluminum rims Hendrickson Intraax Air ride suspension with 25,000 pound axles Shur-loc Roll Tarp

Click on your state to get sales information!