|
| 
|
| Steel Belt Trailer Specifications |
- Floor chain is 88XH Pintle Chain, 2 strands
- Easy access belt adjustment at front of trailer
- Bolt on 5th Wheel
- Gear drive is Eskridge Gear #9, 130,000 inch-lb torque,18,000 pound radial load
- 2-15/16" diameter rear drive shaft, with weld on sprockets and splined hub
- Hydraulic top hinge main gate is 41" above top of trailer when open
- Plastic floor liner is UHMW 3/8" thick, full width
- Plastic Side liner is HMW 3/16" thick one piece, trailer is fully lined
- Extended rear discharge with wings on rear of trailer
- Mechanical latch on rear gate (operates with knife gate)
- Hydraulic pressure line filter with replaceable element
- Hydraulic Control Valve and Flow control mounted at left rear, pressure gauge
- Main Frame Rails are 10" I-beam, one piece, full length
- Sides of trailer only have one seam
- 50,000 lb Landing Gear
- A B S brake system, 2S/1M anti-lock brake system Haldex
- Front and rear fenders
- 11x22.5 radials on 10 bolt hub pilot rims
- Tandem axle
- 25,000 lb axles, cast drums, 16.5x7 s-cam brakes and park brakes on both axles
- Hendrickson Intraax air ride suspension with Haldex quick acting leveling valve
- Trailer is sand blasted, 2 part epoxy primer with 2 part polyurethane top coat
- DOT lighting and reflective tape
|
